diff --git a/Home.md b/Home.md index 829d8b3..4a020e6 100644 --- a/Home.md +++ b/Home.md @@ -147,7 +147,9 @@ If you sure all displays will work properly it's time go on with the assembling # Complete the assembling -First, disassemble the displays and place all the 10mm female - female standoffs at the front of the main PCB with the 6mm screws. Keep in mind that at te corners at the back you have to use the 8mm female - male standoffs, this also applies to the middle 2 at the top of the back. At the bottom of the middle 2 you also have to use the 8mm female - male standoffs but these ones need a nut. Place on each 10mm standoff on the top of the standoffs an 1mm washer, place the displays on the top of them and mount them with the 6mm screws. But keep in mind that at the corners on the top of the fist (left corner) and last (right corner) display you don't use a screw yet, this is where the screw come to mount the front pcb in combination with acrylic front. Don't mount the front yet, we first have to mount the acrylic back with 8 6mm screws, after that it's time to mount the frond PCB in combination with acrylic front with the 4 8mm screws. Note that at the under corners you have to use an extra 1mm washer. +First, disassemble the displays and place all the 10mm female - female standoffs at the front of the main PCB with the 6mm screws. Keep in mind that at te corners at the back you have to use the 8mm female - male standoffs, this also applies to the middle 2 at the top of the back. At the bottom of the middle 2 you also have to use the 8mm female - male standoffs but these ones need a nut. Place on each 10mm standoff on the top of the standoffs an 1mm washer, place the displays on the top of them and mount them with the 6mm screws. But keep in mind that at the corners on the top of the fist (left corner) and last (right corner) display you don't use a screw yet, this is where the screw come to mount the front pcb in combination with acrylic front. Don't mount the front yet, we first have to mount the acrylic back with 8 6mm screws, after that it's time to mount the front PCB in combination with acrylic front with the 4 8mm screws. Note that at the under corners you have to use an extra 1mm washer. + +![BTClock Screw Legend](https://github.com/dsbaars/btclock_v2/assets/480514/c235fc98-9165-4e0f-af4d-68f5f34d574c)