From 05ed35dc05353221e20c72f51b511e1bd2a0264b Mon Sep 17 00:00:00 2001
From: Madbo <60196891+Tinus016@users.noreply.github.com>
Date: Fri, 14 Jul 2023 23:03:38 +0200
Subject: [PATCH] Updated Home (markdown)

---
 Home.md | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/Home.md b/Home.md
index e5a72c6..d1f9e6a 100644
--- a/Home.md
+++ b/Home.md
@@ -1,4 +1,4 @@
-# *BTClock V.1-22 Building Instruction. (By Djuri B. and MadBo)*
+# *BTClock V.1-22 Building Instruction.*
 
 This instruction will guide you through the building process. Please read carefully before you start building, some parts have polarity, keep this in mind during the process.
 
@@ -48,6 +48,8 @@ First of all, check we have all the necessary components.
 
 ---
 
+# Assembling the main PCB.
+
 <img src="https://github.com/dsbaars/btclock_v2/blob/main/doc/IMG_2158.jpeg" width="500"/>
 <img src="https://github.com/dsbaars/btclock_v2/blob/main/doc/IMG_2159.jpeg" width="500"/>
 
@@ -93,6 +95,8 @@ Now it's time to solder the 2X4 2.54 male headers to the e-Ink displays. The cho
 
 ***
 
+# Installation of the Software.
+
 You have done it; all parts are on the main PCB now! Before we continue to build the clock together we fist wand to test the displays, so it's time to upload the software to de Wemos S3 Mini. To do this we need [Visual Studio Code.](https://code.visualstudio.com/Download) Please follow the installation instructions before you continue. 
 
 When you successfully installed VSC (Visual Studio Code) follow the following steps to upload the code to the Wemos S3 Mini.
@@ -132,6 +136,8 @@ If you sure all displays will work properly it's time go on with the assembling
 
 ---
 
+# Complete the assembling
+
 First, disassemble the displays and place all the 10mm female - female standoffs at the front of the main PCB with the 6mm screws. Keep in mind that at te corners at the back you have to use the 8mm female - male standoffs, this also applies to the middle 2 at the top of the back. At the bottom of the middle 2 you also have to use the 8mm female - male standoffs but these ones need a nut. Place on each 10mm standoff on the top of the standoffs an 1mm washer, place the displays on the top of them and mount them with the 6mm screws. But keep in mind that at the corners on the top of the fist (left corner) and last (right corner) display you don't use a screw yet, this is where the screw come to mount the front pcb in combination with acrylic front. Don't mount the front yet, we first have to mount the acrylic back with 8 6mm screws, after that it's time to mount the frond PCB in combination with acrylic front with the 4 8mm screws. Note that at the under corners you have to use an extra 1mm washer.
 
 After that your clock should look like this